Crystal Shell 360: protection, cable storage and plug holder
Protect the wallbox. Store the cable. Give the connector its place.
Designed by M2 Work’s VoltaCover design centre, the 360 family brings wallbox shielding, manual cable storage and a connector holder together in one coordinated structure.
Explore Crystal Shell 360 · Explore Station 360
Protection comes first
Crystal Shell remains at the centre: an upper and front polycarbonate screen with open sides for access and natural ventilation. The module adds a stainless steel plate for organising the cable and connector. Shielding applies to the covered surfaces; the system remains open and does not change the wallbox IP rating.
Choose the configuration
| Configuration | Included elements | Installation |
|---|---|---|
| Crystal Shell 360 | Crystal Shell + stainless steel plate with cable and plug holders | Wall or compatible support; pedestal excluded |
| Crystal Shell Station 360 | Crystal Shell 360 + hollow pedestal with internal cable routes | Ground mounting on a suitable foundation and anchors |
| Cable Dock 360 · in preparation | Stainless steel plate with cable and plug holders, without Crystal Shell | Wall or compatible pedestal |
| Pole 360 · in preparation | Separate pedestal without the upper module | For Crystal Shell 360 or Cable Dock 360 |
Vertical or horizontal: the module changes orientation
The upper module can be positioned vertically or rotated 90° for horizontally shaped wallboxes, subject to dimensions, mounting points and connector access. The pedestal remains upright. This does not permit rotating a charger against its manufacturer’s instructions.
Manual storage for approximately five metres of cable
The structure is designed around storing roughly 5 metres of charging cable around the module, with the connector in its holder. Actual capacity depends on cable diameter, stiffness and bend radius. It is a manual holder, not an automatic reel. During charging, arrange the cable according to its manufacturer’s instructions.
Before or after wallbox installation
Dedicated openings allow cable routes to be planned for a new installation or an existing wallbox. In Station, the hollow pedestal routes wiring to the upper module. An installer must specify the foundation, fixings and connections for the site.
Cable organisation without the Crystal Shell screen
Cable Dock 360 and Pole 360 are separate components being prepared for the catalogue. Combining them creates a freestanding cable and connector holder without Crystal Shell front shielding. Prices and included parts will be specified before sales of the separate components open.
Before ordering
Check the charger, inserted plug, cable bends, controls and required clearances. Confirm that the connector fits the holder. The complete systems do not include the wallbox, charging cable or connector.
Explore Crystal Shell 360 · Explore Station 360 · All wallbox protection